济南江河数控

中文版 | ENGLISH | РУССКИЙ

Your position:主页 > TECHNOLOGY >

江河数控、雕刻机

2013-06-14 10:21Woodworking engraving machine maintenance

Woodworking engraving machine work process itself is a great dust, many users do not clean up the trouble, and let the machine filled with stuff, this approach is wrong, we should be good for woodworking engraving machine maintenance, so that it Better work for us.

Computer aspects:
Regularly killing the virus, but be careful not to open antivirus degree work, careful interference.
Clean the cabinet periodically dust, pay attention to the chassis cooling, carefully dust caused by excessive industrial card error.
Regularly defragment the hard disk to optimize the computer system.
Clear up
Regular cleaning of industrial containers, dust on the circuit board of the biggest killers.
Regular cleaning of the screw, to prevent a foreign body stuck on the screw, screw in the device's accuracy and plays an important role in the transmission process.
Work is done should be cleared up table, which gives the wood engraving machine next work provides a convenient.
Clean the side guides and rails of the material chips, due to interference in order to prevent debris from the machine in the course of card machine.
Oil
After filling slowly back and forth to ensure that oil can be uniformly applied on the rail and the screw.
If the machine unused for long periods, you should regularly refuel idling to ensure that the transmission system flexibility.
First clean the rails with the screw, use cloth (do not shed) on the rails and screw the oil and material debris cleared away.
Low temperatures, can all add to the rails and screw the oil, the best add antifreeze oil.
Refueling cycle twice a month, that is, once every two weeks plus oil.
Temperature
The machine when not in the best if the lower temperature pour the water tank, water tank and pipes to prevent cracking.
Ensure that the operating room ambient temperature, woodworking engraving machine best to reach room temperature, at least the staff will not cold.
Check the fuel standards for temperature, at least the minimum temperatures.
Cooling water
Conditional use antifreeze cooling.
Note that the ambient temperature, careful because the water temperature too cold and cause the water tank and pipe cracking.
Spindle motor cooling water necessary for normal work conditions, if the cooling water is too dirty would cause serious damage to the motor.
Note that the water level, water-cooled spindle motor will not allow water shortages occur, the motor heat can not be exported.
Add: No.999 Hualong Road, Jinan city, China
TEL:86-0531-89001332 13864197735 18906416766