济南江河数控

中文版 | ENGLISH | РУССКИЙ

Your position:主页 > TECHNOLOGY >

江河数控、雕刻机

2013-06-20 10:31Woodworking machine motor unsynchronized Cause Analysis

In the process of using wood engraving machine, woodworking machines we have in order to ensure smooth operation and running accuracy, when the two motors in the assembly before they can be fully synchronized, if you do not synchronize the machine will not operate properly. We are talking here not synchronized woodworking machine motor is mainly for the Y-axis dual motor drive rack woodworking engraving machine is concerned, it is mainly depends on the transmission structure woodworking machines, engraving equipment rack drive by the Y direction is generally there are two motors to run synchronously.

Why wood engraving electromechanical opportunity to appear out of sync it? More common is caused by loose belt, belt loosening and machine routine maintenance and upkeep of a great relationship, if we usually do not clean up the rack above the debris, dust, timing belt run to a miscellaneous the place where the material will force suddenly becomes large, so long there will be loose and eventually will lead to both sides of the motor is not synchronized. Then the machine parameter settings, there were a "linear acceleration" parameter, for rack drive woodworking engraving machine for this value should not be too large, generally set at 300 or so on, if the parameter value is too large, the machine at the start due to start too quickly when bad teeth together, can lead to both sides of the motor is not synchronized. Another stepper drive failure will cause the computer to transmit a signal to the stepper motor distortion occurs, resulting in the number of steps on both sides of the motor caused by inconsistent running of sync problem occurs if the drive customers to contact woodworking machine manufacturers give replacement.
Add: No.999 Hualong Road, Jinan city, China
TEL:86-0531-89001332 13864197735 18906416766