济南江河数控

中文版 | ENGLISH | РУССКИЙ

Your position:主页 > TECHNOLOGY >

江河数控、雕刻机

2013-06-29 14:10Engraving machine tool installation steps

Engraving machine spindle motor with collet clamping tools, tool clamping directly affect the quality of the carving precision, detail, let's look at the knife on the steps of:

1, due to open engraving machine spindle chuck has many gaps, requiring each clamping tool, you must use gasoline or WD40 cleaning agent will chuck cleaned and checked, remove the chuck crevices residue.
2, chuck and shaft with shaft cone by air contact, if contact is not good, the tool is easy to install, to ensure good contact cone. The knife before cleaning agent with gasoline or WD40 will chuck and shaft cone cleaned.
3, the chuck into the pressure inside the cap, gently turn the spring clip until the pressure cap chuck eccentric portion recessed groove along the direction of the arrow evenly push chuck, you can mount pressure cap.
4, engraving machine chuck pressure cap installed together with the engraving machine spindle, the tool shank portion wipe aid loaded after clamping hole, put positive confirmation chuck and tool, hand tighten the pressure cap in place, and then use a wrench tighten the cap evenly, until the tool firmly until the clip before use.
5, loose knife pressure cap screw with a wrench direction, if needed change chuck, loosen the pressure cap with a chuck and the tool, remove the tool, push hard chuck direction of the arrow to launch, and then needs to be replaced on the other aperture chuck can be.
Add: No.999 Hualong Road, Jinan city, China
TEL:86-0531-89001332 13864197735 18906416766