济南江河数控

中文版 | ENGLISH | РУССКИЙ

Your position:主页 > TECHNOLOGY >

江河数控、雕刻机

2013-07-03 10:46Engraving machine troubleshooting

1, X, Y, Z-axis does not move one, is their corresponding drive is damaged.

2, X, Y, Z axis in which a shaft misalignment, carve should check whether the drive is a problem, check the system re-install; checking mechanical coupling is loose, engraving machine too fast, the voltage is too low, check the control card.
3, lettering shades, platform uneven, with the milling cutter clean countertops leveling can be.
4, the machine's electrical power is small, look at whether there are screw or bearing debris, clean up what you can.
5, the drive appears reversing the situation look cables are reversed.
6, boot no response, check the big line is broken, Desoldering, check the signal cable is loose.
Add: No.999 Hualong Road, Jinan city, China
TEL:86-0531-89001332 13864197735 18906416766