济南江河数控

中文版 | ENGLISH | РУССКИЙ

Your position:主页 > TECHNOLOGY >

江河数控、雕刻机

2013-07-10 14:19Engraving depth adjustment

Stone engraving machine cutters are used in the factory before leveling, there will be no countertops rugged conditions, but the customer is used to carve stone some margin of error, not up and down about the same level. When we lower left corner of the material on the knife, it is likely that the highest point of the entire board, the actual carving, when some other relatively low may be just the place where the sculpture that may be relatively shallow engraved no results. If this is the lowest point of the material, then the other places will be carved deeper, in short, the effect will not look good. Stone engraving machine engraving depth and set the actual depth of inconsistent solution:
1, the machine origin, when the XY-axis and the Z axis will be detached to, XY axes or positioning the lower left corner of the material, Z-axis moves to the middle of the material of the knife, so that the depth will be carved out of a number of relatively uniform. If the material is too much difference, it needs to be engraved on the lower path is divided into three parts or two parts to be kept separate, or when the knife in the lower left corner of XY, Z axis is carved into each part of the time that part of the corresponding in the middle to go right, so carving effect would be more better.
2, the use of the four corners of the machine measuring some of the plates, according to the X-axis data look at which position is high, which position is low, then the material below the appropriate pad something, try to keep the material level.
Add: No.999 Hualong Road, Jinan city, China
TEL:86-0531-89001332 13864197735 18906416766