Engraving machine motor common faults_我的网站



Your position:主页 > TECHNOLOGY >


2013-07-13 11:50Engraving machine motor common faults

Woodworking engraving machine spindle motor common faults and their solutions:

1, woodworking engraving machine spindle motor hot: first check the pump is working, but also whether the circulating water under the lower level.
2, sensory motor no effort to turn no: To view the circuit, check that the motor cable is phase, or the cable is short-circuited.
3, the motor has a strange voice: Check whether the motor is overloaded, the motor may exist within the fault should be repaired promptly replaced.
4, motor reversal: Direct Check motor cable is UVW phase or the output terminal exchange.
5, woodworking engraving machine has a shaft does not rotate: Check engraving machine corresponds to the driving shaft of the corresponding block is damaged.
Add: No.999 Hualong Road, Jinan city, China
TEL:86-0531-89001332 13864197735 18906416766