济南江河数控

中文版 | ENGLISH | РУССКИЙ

Your position:主页 > TECHNOLOGY >

江河数控、雕刻机

2013-07-17 17:32Stone engraving machine safe operation

1, in the process of abnormal, should be immediately shut down, timely troubleshooting.

2, to maintain the bed and surrounding venues clean, orderly, no oil, parts, lumber, scrap stacked according to regulations.
3, ready to observe the stone engraving machine operation, in order to avoid accidents caused by out of range of the effective stroke.
4, stone engraving machine when starting the operator shall absent without leave, if necessary, should be shut down or leave off the power switch.
5, to put fire extinguisher readily available and the place, do not place in the vicinity of paper, cloth, or other combustible material.
6, after the boot should manually speed X, Y direction switch on the machine, check to make sure whether the abnormal situation.
7, good labor required to wear protective equipment.
8, the input of the new part program, you should first try to run and check its operation.
9, maintenance, compliance with safety regulations.
10, the operator must be trained, familiar with the structure and properties of the device, the operating system to master the relevant knowledge.
Add: No.999 Hualong Road, Jinan city, China
TEL:86-0531-89001332 13864197735 18906416766