济南江河数控

中文版 | ENGLISH | РУССКИЙ

Your position:主页 > TECHNOLOGY >

江河数控、雕刻机

2013-07-19 16:51Engraving machine spindle problem

1, the spindle can not operate normally, first check the drive LED display shows the error code.

2, there is a shaft axis can not move, this time to check the corresponding axis corresponding to the drive block is damaged. Inspection methods can use the substitution will not corresponding to the air shaft Unplug other dynamic shaft inserted in the corresponding drive on.
3, if the switch does not move after move normal axis, the axis may explain the corresponding drive block has been damaged and need replacing a good drive block, if you do not drive shaft or not it shows a faulty cable or replace the motor cable or motor. Triaxial not active, then check whether the air plugs and three-axis control box connected, the control box is powered on, the data line is and the control box and the computer host controller card connected. If the above are normal, please contact the party and sculpture factory.
Add: No.999 Hualong Road, Jinan city, China
TEL:86-0531-89001332 13864197735 18906416766