济南江河数控

中文版 | ENGLISH | РУССКИЙ

Your position:主页 > TECHNOLOGY >

江河数控、雕刻机

2013-07-20 21:47Stone engraving machine tips

We are working in the use of stone carving machine, sometimes the software inside the engraving depth has been set, but the processing out of the engraving depth is not the same, this is because the material in some places high in some places, but this kind of material smoothness is poor, can be treated like this: when we generate tool path can be divided into, three parts, the three part is divided into three paths to save, when the actual carving origin or identified in the material in the lower left corner, good will X, Y axis workpiece coordinate reset. The Z axis tool according to the tool path we load the set, if we start processing the top part of a tool, will move to the middle region of the part of tombstone, then confirm the Z axis 0 plane can be, the remaining two sections is the same, so the engraving depth will mean for some, the effect is much better.

Add: No.999 Hualong Road, Jinan city, China
TEL:86-0531-89001332 13864197735 18906416766