济南江河数控

中文版 | ENGLISH | РУССКИЙ

Your position:主页 > TECHNOLOGY >

江河数控、雕刻机

2013-10-18 11:58Engraving depth setting

Using stone engraving machine at work, and sometimes the software inside the engraving depth set, but the processing out of the engraving depth is not the same, this is because the material low in some places high in some places, and for comparison of such material flatness poor, it can be to deal with: the generated toolpath when we can divided into upper, middle, and lower parts, these three parts is divided into three paths to save, the actual origin of carving or determine when the lower left corner of the material , the future will be a good X, Y axis workpiece coordinate cleared. z-axis of the knife blade to be loaded according to our way to set up, if we first processing that part of the top, it is necessary to move the tool to the part of the tombstone in the middle zone, and then determine what z-axis 0 plane on it, left the two parts is the same reason, so that would mean some of the engraving depth, the effect is much better.

Add: No.999 Hualong Road, Jinan city, China
TEL:86-0531-89001332 13864197735 18906416766